Auckland home theatre cabling — wired cleanly, from $650 per room.
Whether it's a new media room or a lounge AV upgrade — we plan, run, terminate and test every cable before your electrician mounts the TV. No dangling HDMIs. No stapled speaker wire. No "we'll tidy it later."
Free on-site AV survey
We walk the room with you, mark screen and speaker positions, plan every concealed route, and email a fixed-price quote within 24 hours.
- 45 mins on-site — usually same week
- Fixed-price written quote in 24 hours
- Honest read on what the room can support
- Free coordination call for builders & PMs
Auckland-wide · licensed electrician on hand
Four ways we wire a home theatre
Same crew, same standards — whether it's one lounge wall or a whole house.
Concealed cabling
Every cable behind the wall, in the ceiling or under the floor. Nothing dangling, nothing stapled, nothing "tidied later".
Full AV integration
TV, projector, receiver, streaming box and speakers all wired to one plan so the whole system talks to itself properly.
Multiroom audio + video
Music in the kitchen, the match on the deck, a film in the media room — distributed from one place, not five apps.
New builds + retrofits
Pre-wire while the walls are open, or retrofit into an existing home through the ceiling void and subfloor.
You've got the TV. Maybe a soundbar. But then it all starts to unravel.
Cables visible down the wall. Sound that never quite balances. A streaming box that drops out at the worst moment. Three remotes fighting over one input. None of that is a gear problem — it's what happens when good equipment is connected badly.
A cowboy AV install mounts the TV, dangles the HDMI, hides nothing in-wall, staples the speaker wire to the skirting and calls it done. We do the opposite: plan the routes first, run everything concealed, test every cable, and hand you a label directory so the next change takes minutes.
Cables visible behind the TV
In-wall HDMI and power relocation puts them out of sight for good.
Surround sound that never balances
Speaker positions planned to the seating line, not to where the cable happened to reach.
Streaming that buffers mid-film
A wired Cat6 drop to the TV ends the WiFi lottery.
Devices that won't talk to each other
One wiring plan for the whole rack instead of six one-off fixes.
What we wire in a home theatre
Six lanes of work. You might need one of them or all six — the survey tells us which.
TV & projector HDMI runs
Concealed HDMI from the screen position to the equipment location, pulled through conduit so a future upgrade is a swap, not a wall repair.
In-wall, conduited, tested end to endIn-wall & in-ceiling speakers
Speaker cable run and terminated for 5.1, 7.1 or Atmos layouts, openings cut cleanly and your chosen speakers fitted.
5.1 · 7.1 · Atmos layoutsCat6 network for streaming
A wired drop to the TV, receiver and streaming box so 4K plays without the buffering everyone blames on the gear.
Fluke-tested on completionConcealed AV rack tidy
Receiver, streamer and network gear racked in a cupboard, cable-managed and labelled so nothing is a mystery in two years.
Labelled both endsMulti-room audio + video
Distribution wiring so the same sources reach the lounge, kitchen, deck and media room without a box in every room.
Zoned, single source stackTV socket + power relocation
Licensed electrician on hand to move the power point behind the wall-mounted TV so the last visible cable disappears too.
Licensed mains work includedHome theatre cabling from $650 per room
Three fixed-price shapes. The survey turns the "from" into an exact number in writing within 24 hours.
Lounge Upgrade
One room done properly — the TV wall in the family lounge, cables gone for good.
Per room, supplied & installed
- Concealed in-wall HDMI run
- Fluke-tested Cat6 drop for streaming
- One pair of speaker runs
- Tidy termination + make-good
- 3-year workmanship warranty
Dedicated Media Room
A proper cinema room — projector, surround layout and a tidy rack behind the scenes.
Full room, supplied & installed
- Projector or large-screen HDMI runs
- 5.1 / 7.1 / Atmos speaker wiring
- In-wall + in-ceiling speaker fitting
- Concealed AV rack build + tidy
- Cat6 backbone + label directory
- Same-day fixes or your call-out is free
Whole-Home AV
Audio and video everywhere it's wanted, wired from one source stack.
Multi-room, supplied & installed
- Multi-room audio + video distribution
- Whole-home Fluke-tested Cat6 backbone
- Media room + lounge + outdoor zones
- Central rack, patch panel + labelling
- Documented handover pack
Every price is a starting point, not a guess at your house. Book a free site survey for the exact number — in writing, within 24 hours, with no obligation to proceed.
Is this the right job for us?
We'd rather tell you now than waste your survey slot.
Yes — this is us
- Building or fitting out a dedicated media room
- Upgrading the family lounge — TV, speakers, streaming
- New build pre-wire, coordinated with your builder
- Renovation retrofit while the walls are open
- Fixing a previous install that was left visible or unbalanced
Not us — and that's fine
- TV wall-mount only, no cabling — give us a call and we'll point you the right way
- Speaker or gear supply only — we're installers, not retail
- Setting up an app or pairing a remote — that's a 10-minute job, not a call-out
- Repairing faulty AV equipment — that's a warranty claim with the manufacturer
Four steps from survey to handover
Same process whether it's one wall or the whole house.
Site survey
45 minutes on-site. We mark screen and speaker positions, check ceiling and wall access, and plan every concealed route.
Plan + fixed quote
A cable plan and a fixed-price written quote in your inbox within 24 hours. No hourly rates, no surprises on the day.
Wire it
Everything concealed and Fluke-tested. Coordinated with your builder on new builds, sequenced tidily for retrofits, make-good every time.
Handover
Label directory, tested runs and a 3-year workmanship warranty in writing — so the next change takes minutes.
Real Auckland home theatre installs
Photos from recent jobs — cables you can't see, which is rather the point.
Photos to be supplied by Namra — placeholders in place for Stage 3.
What Auckland homeowners say
"We'd had two quotes that both wanted to run the HDMI down the outside of the wall. These guys went through the ceiling, moved the power point behind the TV, and you genuinely cannot see a single cable."
"Media room in a new build, wired before the gib went on. They talked to our builder directly so we didn't have to project-manage it, and the label directory made setting the gear up trivial."
"Our surround never sounded right and the Apple TV kept dropping out. Turned out both were wiring, not gear. Wired drop to the TV and the speakers repositioned properly — completely different room now."
Placeholder testimonials — to be replaced with Namra's real HTC reviews before publish.
Home theatre cabling FAQ
Can you hide all the cables in an existing home?
Do I need Cat6 or Cat6A for 4K streaming?
Can you install in-wall or in-ceiling speakers?
How long does a whole-home AV wire take?
Do you work with my existing TV, receiver and streaming gear?
Will I need a builder, or can you cut the walls?
What's included in the $650 per room price?
Do you pre-wire during construction?
You may also need
The systems that ride on the same cabling visit.
Book your free home theatre survey
45 minutes on-site, a real number in writing within 24 hours, and no obligation to proceed. Same-day fixes if we miss anything — or your call-out is free.
Auckland-wide · from $650 per room · 3-year workmanship warranty · Site Safe + $5M PL